Configuration Instructions

Configuration pages – Overview
'Peripherals and Supervision'
6
A6V10429097_en--_e
123 | 219
6.7 'Peripherals and Supervision'
6.7.1 External UART & Cyclic Settings
Fig. 79: External UART & Cyclic Settings
The external UART interface supports several protocols. To display cyclic debug
information, the default value is set to 'General debugging protocol'.
Cyclic Settings
The most important setting is 'Cyclic Interval'. See chapter 'Change Cyclic
Intervals [➙ 192]'.
'UART'
The external UART interface supports several protocols.
'Enable the external UART'
Used to switch the function of the serial interface.
'UART Speed'
Set the baud rate of the interface. Supported speeds are 9600, 19200 (default),
57600 and 115200
'UART Parameters'
Fixed value: no parity, 8 data bits, 1 stop bit
'SysLog Interval'
You can adjust the interval for transmitting data. For example the 'CSLL protocol'
should send the levels more often, so the time to set is 100 ms. For the 'RSL
protocol', 10 s is appropriate.