Mounting Instructions

Install internal components
Input/Output extension (digital 16) PCIO2001-A1
6
A6V10430579_en--_b
113 | 173
6.23.3 Configuration with the ID jumper
The ID jumper must be set to the correct values to identify the components on the
'PACE-Bus' (RS485). The ID must be unique on one 'PACE-Bus' (RS485).
The ID jumper 7 and 8 are used to set the RS485 address.
7
8
ID
0
0
10
0
1
11
1
0
12
1
1
13
Table 72: PCIO2001-A1 set the RS485 address with ID jumper
● 0 = OFF; no jumper is set
● 1 = ON; jumper is set
ID jumper 1 to 3 settings:
ID
jumper
Function
1
Analog control inputs are used as supervised inputs
2
Analog control inputs are used to supervise relay outputs
3
Logic control inputs 1 to 8 are used as relay controls
Table 73: PCIO2001-A1 function settings with ID jumper
The ID jumper 4 to 6 are reserved for future application and should stay in the
OFF position.
6.23.4 Connect DC 24 V power supply
The PCIO2001-A1 provides two DC 24 V power supply connectors ('X1' and 'X6')
DC 24 V power supply connectors - 'X1' and 'X6'
Pin
Description
Remark
1
DC 24 V
Power supply
2
DC 0 V
Power supply
Table 74: PCIO2001-A1 DC 24 V power supply connectors - 'X1' and 'X6'