Configuration Instructions

Maintenance and system operation
'Extras' > 'Station' menu
10
184 | 219
A6V10429097_en--_e
10 Maintenance and system operation
10.1 'Extras' > 'Station' menu
Fig. 134: 'Extras' > 'Station' menu
10.1.1 Mirror Copy
● The Mirror Copy is an area in the device’s flash that can be used to back up the
entire device configuration.
● If, for some reason, the original configuration block is damaged, the device
starts with the mirror copy.
● The Mirror Copy is updated automatically during specific device functions,
these are:
– During a DSP Firmware Update (at start of 'Updating Settings', after writing
the DSP’s Firmware succeeded
– Before applying the User settings [➙ 194] to the device
– Before a Clone Station [➙ 187] command
– Before a Reset Station to the Factory Settings [➙ 188] command
● With the '>Update Mirror Copy<' command you can copy the whole
configuration block to the mirror area at any time.
● The function 'Check Mirror Copy of Station' compares the original
configuration block with the mirror copy, shows the most important differences
and can restore the configuration block from the mirror copy.