Configuration Instructions

Safety
Standards and directives complied with
2
A6V10429097_en--_e
23 | 219
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
● Personal injuries or damage to property caused by improper use and incorrect
application
● Personal injuries or damage to property caused by disregarding safety
instructions in the documentation or on the product
● Personal injury or damage to property caused by poor maintenance or lack of
maintenance
2.3 Standards and directives complied with
A list of the standards and directives complied with is available from your Siemens
contact.
2.4 IT security notices
Responsibility of the system owner
The information technology (IT) used in a system is the responsibility of the system
owner.
National standards, regulations and legislation
Specifications for IT security are also put into effect through country-specific
legislation. You must observe the country-specific legislation when planning and
commissioning.
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional country-specific or
local security standards or legislation concerning IT security apply at the place of
operation, you must apply these in addition to the guidelines and the permitted
applications in this document.
The 'Federal Office for Information Security' (BSI) www.bsi.bund.de/EN provides
information on basic IT security for Germany in both German and English, for
example.
Siemens Network Security Guidelines
The Siemens network security guidelines in this document provide the system
owner with additional specifications – alongside basic IT protection– for operating a
corresponding system. These additional specifications are valid at the time of
publication.
NOTICE
Modified Security Risks in the Life Cycle of the System
Additional security risks
● You must log compliance with the specifications in chapter 'Maintenance of
IT components [➙ 204]'