Configuration Instructions

System configuration
Setup the supervision extension card
5
52 | 219
A6V10429097_en--_e
5.5.2 Setup a loudspeaker line
◈
Specify a set detection method for each speaker line/each output.
The detection methods are described in the following chapters.
5.5.2.1 Pilot tone only detection
Only the values from the 'Pilot RMS [V] Value' + 'Tolerance' fields are evaluated in
the measurement algorithm.
Fig. 19: Pilot tone only detection
1. Enable the 'En' flag for each zone you want to monitor.
2. Set 'Pilot Only' under 'Type'.
 Only the following errors can be detected:
● Faulty wiring
● Amplifier fault