Configuration Instructions

System configuration

Using the PT2006 remote control panel

72 | 219

A6V10429097_en--_e

5.14.2 Configuring a preset

◈

Open the 'Peripherals and Supervision' page and the 'PACE-Bus' tab.

If you don’t see the Config Preset tab, open the Device ID= Dropdown menu,

select a device form the list and press Accept. If no devices are listed in the

dropdown, check the bus wiring and the power supply of the modules.

Fig. 39: 'Config Preset 1' tab

1. Select 'Vol and Ch +/-' in 'Allowed Views'.

– The station ID must match the ID of the local matrix. Other matrix devices

cannot be controlled remotely.

2. Choose the Audio Outputs, a module is able to control.

– If more than 1 output is enabled, all selected outputs will be controlled at

the same time

3. To control only 1 output and switch between the configured ones, enable the

cycle through outputs flag

4. Click on 'Add all Channels' and remove the channels not selectable by the

modules.

5. Press <Ctrl> and click on 'Add all Channels' to enter a single channel only.

– Channels 1…127 are valid. It is not possible to select priority channels.

 If you change a preset configuration, all devices routed to the same preset will

receive the new configuration

5.14.3 Routing a preset to the panels

1. Select a device ID from 'Device Configuration Type = UPD'

2. Choose the configuration from the four drop down selection fields,

3. Set <function> of <own station id> Audio <output mask> Channels <allowed

feeds>