User Manual

3
Siemens
A6V11521024_en--_b
Smart Infrastructure
2019-09-27
Ordering
Please specify the quantity, product name, ASN (product number) and SSN (stock number)
when ordering. The following table gives some examples.
Quantity
Product name
ASN
SSN
1 Climatix capacitive touch panel POL8T5.70/STD S55626-H857-A100
10 Touch Panel cable RS485 POL0C1.75/STD S55843-Z717-F100
10 Touch Panel cable RS485/Ethernet POL0C1.80/STD S55843-Z718-A100
Notes
Engineering notes
WARNING
The design complies with SELV conforming to EN 60730-1. To ensure protection against
accidental contact with any other party carrying voltages above 42 V
rms,
take care of
connection when wiring.
CE note
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Disposal
The device is considered an electronic device for disposal in accordance
with the European Guidelines and may not be disposed of as domestic
garbage.
● Dispose of the device through channels provided for this purpose.
● Comply with all local and currently applicable laws and regulations.
FCC compliance notes
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
● This device may not cause harmful interference
● This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
● Consult the dealer or an experienced radio/TV technician for help.