User Manual

Siemens Industry, Inc.
Building Technologies Division
P/N 315-099321-78
Battery Connections When BTX-1, BTX-2 or BTX-3 batteries are required, connect them to the system
with the Battery Cable Conversion Kit, P/N 545-634222, following the steps listed
below. (Refer to Figure 7.)
1. Using the 12 in. long wire assembly, connect the two batteries together, as
shown in Figure 6. Secure each end of the assembly to the battery with a
10-32 x 3/4” screw and lock nut.
2. Attach the quick disconnects to the positive and negative battery terminals
with the 10-32 x 3/4” screws and lock nuts supplied.
3. Attach the red battery wire to the quick disconnect on the positive terminal
and the black battery wire to the quick disconnect on the negative terminal.
BTX-1, BTX-2 OR BTX-3
BATTERIES
10-32 X 3/4”
SCREWS
(4 PLACES)
12 IN. LONG
WIRE ASSEMBLY
LOCK NUT
(4 PLACES)
QUICK
DISCONNECT
(2 PLACES)
Figure 7
Wiring BTX-1/-2/-3 Batteries To The PSC-12
Power Supply Load Calculations
MROFNOITALUCLACDAOLYLPPUSREWOP
/draC
eludoM
ytitnauQ
tnerruCCDV42eludoM/draC tnerruCCDV2.6eludoM/draC
tnerruCenalPkcaB
V42lanimreTwercS
tne
rruC
CDV42latoT
tnerruC
latoT+1latoT(
)2
reP
eludoM/draClatoT
reP
eludoM/draC1latoT
reP
eludoM/draC2latoT
4-BUH0 Am004Am03
C
-CINAm02100 0
LATOT
tontsuM(
2deecxe
)spmA
LATOT
deecxetontsuM(
nispmA5
spmA21,ybdnats
)mralAni
LATOT
tontsuM(
2deecxe
)spmA