Configuration Instructions

System configuration
Using keypad macros
5
92 | 219
A6V10429097_en--_e
Macro ID
Additional params
Description
Supported button modes
'A'
asc(65), 0x41
Select all configured zones
for this station 1
Select all zones while active
PlaySound_FLASH
TalkButtonPlaySound_S
D
PushButtonSwitch L>H:
'Talk2' Button (2)
'a'
asc(97)
0x61
Byte0: stateID
1: localAlarmState
Byte1: stateValue
0: No alarm (no local alarm
since start)
1 Alarm currently triggered
2 Alarm currently silenced
3 Alarm currently reset
4 Alarm stopped by BMZ
5 Alarm manually stopped
StateID=2: zoneSelection
Byte1: zoneSelectID
0: allow if all zones
selected
1: allow if not all zones
selected
StateID=3: macroFlag
Byte1:
0: allow if MacroFlag is set
1: allow if MacroFlag is not
set
MSB(b7) of stateID used to
allow key but avoid further
macro processing
Allow key on specified state
This key could be only activated if a
given state is present on the local
station or within the global system
no further macros are processed
'Allow key only if a given state is
present on the local station or within
the global system'
PlaySound_SD,
PlaySound_FLASH 'Talk'
/ 'Talk2' Button
PushButton
Switch L>H,
Macro_mode
Zone Select (2)
FW1.3B5-1 supports
suppressing of macro
processing via MSB
‘B’
asc(66)
0x42
Byte0: behaviour
0=muted
1=normal
2=priority mode
0xFF=toggle between
mute&normal
Byte1: outputmask
Byte2-3: stationID
(0=SuppSelf)
Behavior set to given value
'Verhalten eines spezifischen
Ausgangs ändern'. In PRG mode only.
Macro_Mode
'c'
asc(99)
0x63
Byte0:
0: Clear all states below
240
1: Clear 5416-Alarm states
2: Reset all pressed keys
3: Reset all Leds
Used to clear pending EN 54-16
states e.g. silencing active...
'Clear all or specific states present on
this station'
Macro_Mode, 'Talk' /
'Talk2' Button,
PushButton
Switch L>H,
Macro_mode
Zone Select (2)