User Manual

ManualsBrandsSiemens ManualsOperator unitsZone Room Unit QAW810

AP1N2724en

28.08.2007

Building Technologies

HVAC Products

724

Zone Room Unit

QAW810

for RRV817 Control System

Digital zone control unit as an installer and end-user interface for use with the

RRV817 temperature controller for underfloor heating systems

Use

Room unit in combination with the RRV817 temperature controller for underfloor heat-

ing systems in:

• Apartments

• Detached houses

• Light commercial applications

• Conjunction with district heating schemes or local heat sources

1 QAW810 per zone 2 to 7, in conjunction with the RRV817 temperature controller and

the QAX810 (master) room unit, in water-based heating plant.

Functions

• Zone control and monitoring in combination with an RRV817 plus QAX810

• Zone addressing by the installer

• Room temperature acquisition

• Local zone control and monitoring

• Temporary setpoint adjustment

• Zone comfort, energy saving, auto-timer and standby selection

• Display of operating mode and zone temperature

Plants

Application

Primary functions

Operator functions

Summary of content (6 pages)

PAGE 1
2 724 QAW810 Zone Room Unit for RRV817 Control System Digital zone control unit as an installer and end-user interface for use with the RRV817 temperature controller for underfloor heating systems Use Plants Room unit in combination with the RRV817 temperature controller for underfloor heating systems in: • • • • Application Apartments Detached houses Light commercial applications Conjunction with district heating schemes or local heat sources 1 QAW810 per zone 2 to 7, in conjunction with the RRV817
PAGE 2
Type summary Type reference QAW810 Description Zone room unit Compatible with* • Master room unit QAX810 • Temperature controller RRV817 * Not suited for use with the Desigo RX range of controllers Product documentation Document Data sheet Mounting Instructions Operating Instructions Document number N2724 M2723 B2723 Mechanical design Type of unit The QAW810 is the end-user zone MMI for RRV817 controllers.
PAGE 3
Mounting and installation notes The QAW810 should be mounted in a location where the air temperature can be acquired as accurately as possible without getting adversely affected by direct solar radiation or other heating or cooling sources.. • • • • • • Mounting height is about 1.5 m above the floor. The unit can be fitted to a recessed conduit box. The specified ambient conditions must be observed. Only authorized staff may remove the QAW810 unit from its base.
PAGE 4
DIP switches at the rear of the QAW810 DIP switches They allow setting the address in cases where several room units are connected to 1 RRV817 controller. The room units are delivered with default positions = zone 2.
PAGE 5
4000 V Rated surge voltage Software class Materials and colors A Top housing Polycarbonate, RAL 9003 (signalwhite) Polycarbonate, RAL 7035 (lightgrey) corrugated cardboard Bottom housing and base plate Packaging Norms and standards Product safety Automatic electrical controls for household and similar use Special requirements for temperature sensing controls Electromagnetic compatibility Immunity domestic section, light industry Emissions domestic section, light industry -conformity EMC directive Low
PAGE 6
Dimensions 119 3031M01 Controller 96 28 4 28 26 30 89,45 6/6 Siemens Building Technologies 3035M02 11,8 30 28 112,3 4 35 28 Base 23,8 Dimensions in mm ©2005 Siemens Switzerland Ltd Subject to alteration Zone Room Unit QAW810 AP1N2724en 28.08.