User Manual

52 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
Connecting RF components
Notes
RF components are assigned to rooms or functions.
On the central apartment unit, the required rooms must be configured before-
hand (refer to page 18), the required functions activated and the mode of
transmission set
to “Via RF“ or ”Via RF / S-Mode“ (refer to page 25 ff.).
If, by mistake, a device has been connected twice, the central apart-
ment unit ignores the second connection, delivers an error message
and a beep.
After all devices have been connected, you can check the number of
channels and the connected device types on the device list. Missing
devices can also be added later and devices not needed can be re-
moved.
Connect RF room components
The following RF components can be assigned to a room:
Room unit QAW910
Room temperature sensor QAA910
Radiator control actuator SSA955
Heating circuit controller RRV91…
(only heating circuit actuators)
Door / window contacts wave AP 260
RF components are to be connected room by room. Inform the central apart-
ment unit which room you want to assign RF room components:
Main menu > Commissioning > RF connections
> Rooms > Room X > Connect device:
Confirm entry on submenu “Connect device“ by pressing the Menu/ok button.
To make the connection, press the binding button on the device to be con-
nected.
You can connect all devices of the same room, one after the other, with
no need for making additional entries on the central apartment unit.
Now, switch on all RF components to be connected to the room – one after
the other – and connect them. The order of connection can be freely selected.
The only exception are the SSA955 radiator control actuators and the
RRV91… heating circuit controllers where the control actuator / control chan-
nel of the room connected first serves as the lead controller / lead channel and
the other control actuators / control channels as the lag controllers.
Every connection made appears on the display and is confirmed by a beep.
When all devices of a room / switching group or device class are connected,
close the binding process by pressing the Menu/ok button.