User Manual

70 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
A successful connection appears on the display of the central apartment unit
and is confirmed with a beep. Close the binding process by pressing the
Menu/ok button.
Connect fault outputs
Inform the central apartment unit that you want to use a universal relay output
Qx of a heating circuit controller or multi-controller as a fault output:
Main menu > Commissioning > RF connections
> Faults > Fault output X (1 - 2) > Connect device:
Confirm subentry “Connect device“ by pressing the Menu/ok button. To make
the connection, you are prompted to press the binding button on the device to
be connected.
Select a universal relay output Qx with the channel selection button (CH) on
the heating circuit controller or multi-controller. The LED of the selected chan-
nel blinks. If the selected channel is not yet connected, the binding LED flashes.
Now, press the binding button on the heating circuit controller or multi-
controller. The LED lights up green. When it starts blinking, you can release
the binding button.
A successful connection appears on the display of the central apartment unit
and is confirmed with a beep. Close the binding process by pressing the
Menu/ok button.
Connect inputs
Connect inputs for operating mode contact
Inform the central apartment unit that you want to use a universal input B of a
heating circuit controller or a universal input Xx of a multi-controller for con-
necting an operating mode contact:
Main menu > Commissioning > RF connections
> Inputs > Operating mode contact > Connect device:
Confirm subentry “Connect device“ by pressing the Menu/ok button. To make
the connection, you are prompted to press the binding button on the device to
be connected.
Use the channel selection button (CH) to select universal input B of the heat-
ing circuit controller or a universal input Xx of the multi-controller. The LED of
the selected channel blinks. If the selected channel is not yet connected, the
binding LED flashes.
Now, press the binding button on the heating circuit controller or multi-
controller. The LED lights up green. When it starts blinking, you can release
the binding button.
A successful connection appears on the display of the central apartment unit
and is confirmed with a beep. Close the binding process by pressing the
Menu/ok button.