Data Sheet for Product

ManualsBrandsSiemens ManualsPressostats (pressure)Pressure diaphragm QBE61.3-DP

CM1N1923en

2022-01-21

Smart Infrastructure

923

Differential pressure

sensors

QBE61.3-DP..

for neutral or slightly aggressive gases and liquids

 Operating voltage AC 24 V or DC 18...33 V

 Output signal DC 0...10 V

 Connecting male thread G½"

 3 Versions covering a total differential pressure range of 0…10 bar

 Ceramics measurement system

 High level of safety against overpressures

1923P01

Summary of content (6 pages)

PAGE 1
923P01 1 923 Differential pressure sensors QBE61.3-DP.. for neutral or slightly aggressive gases and liquids       CM1N1923en 2022-01-21 Operating voltage AC 24 V or DC 18...33 V Output signal DC 0...
PAGE 2
Use For acquiring the differential pressures in HVAC plant. Suited for use with the following types of media:  Neutral or slightly aggressive gases  Neutral or slightly aggressive heating water and cold water (with or without additives, such as hydrazine or glycol) Type summary Type reference Accessories Measurement range Max. overload on one side Nominal pressure QBE61.3-DP2 0...2 bar  12 bar PN 40 bar QBE61.3-DP5 0...5 bar  20 bar PN 40 bar QBE61.3-DP10 0...
PAGE 3
Engineering notes The QBE61.3-DP.. and all interconnected devices must be wired to the same G0/G (measuring neutral). Also refer to the Data Sheets of the devices to which the sensor is connected. The differential pressure at the sensor may never exceed the permissible overload on one side (refer to “Type summary”). High static pressure can destroy the sensor if it acts on only one side of the measurement system. This can be prevented by using the following layout: A...
PAGE 4
Technical data Electrical interface Product data Degree of protection Connections Environmental conditions Materials and colors Directives and Standards Environmental compatibility Operating voltage (SELV) Power consumption External supply line protection Output signal Voltage burden Measurement range Sensing element Measurement accuracy at 20 °C Sum of linearity, hysteresis, and reproducibility QBE61.3-DP2, QBE61.3-DP5 QBE61.3-DP10 Zero point Response time Max.
PAGE 5
Connection diagram Legend G (+) U () M (0) Power supply AC 24 V or DC 18...33 V Measured signal output DC 0...10 V G0 /G, measuring neutral Note: the symbols in parenthesis correspond to the terminal marking on the terminal block Dimensions (in mm) QBE61.3-DP.. 4 286 1652 0 Water trap pipe 5/6 Smart Infrastructure Differential pressure Sensor QBE61.3-DP..
PAGE 6
Published by: Siemens Switzerland Ltd. Smart Infrastructure Global Headquarters Theilerstrasse 1a CH-6300 Zug Switzerland Tel. +41 58-724 24 24 www.siemens.com/buildingtechnologies © Siemens Switzerland Ltd, 2000 Subject to change 6/6 Smart Infrastructure Differential pressure Sensor QBE61.3-DP..