User Manual

15 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_06
Building Technologies Mounting and electrical installation 2019-04-08
• Follow the KNX regulations
• For KNX wiring (topology, allowed cables and cable length), see the document
KNX bus Fehler! Verweisquelle konnte nicht gefunden werden..
• Use the correct cables for the KNX bus
• Do not interchange the wires of the KNX cable.
– The red terminal is for KNX +
– The gray terminal is for KNX –
• Observe all local installation regulations.
The devices are not protected against accidental connection to AC 230 V.
Information in topology and addressing in KNX networks is available in document
KNX bus Fehler! Verweisquelle konnte nicht gefunden werden.. The following
information requires electrical installation as per the KNX-TP1 standard.
Remove label
Installation
Caution!
Bus cabling
1602J110
1602Z107