User Manual

5 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_06
Building Technologies About this document 2019-04-08
Before using our products, it is important that you read the documents supplied
with or ordered at the same time as the products (equipment, applications, tools
etc.) carefully and in full.
We assume that persons using our products and documents are authorized and
trained appropriately and have the technical knowledge required to use our
products as intended.
For more details on the products and applications, please refer to:
• On the internet: "Technical product data and descriptions" at
www.siemens.com/gamma-td
• On the intranet (for Siemens employees only) at
http://step.bt.siemens.com/portal/index.html
• At your next Siemens branch office www.siemens.com/sbt or at your system
suppliers.
• From the support team in the headquarters fieldsupport-
[e-mail] if no local POC is available.
Siemens assumes no liability to the extent allowed under the law for any losses
resulting from a failure to comply with the aforementioned points or for the improper
compliance of the same.
0.3 Abbreviations and naming conventions
Abbr.
Description
ACS790
Engineering Tool for Synco devices
ETS
Engineering Tool Software http://www.knx.org/
KNX/ACS
Communication with KNX, configuration with ACS
KNX/ETS
Communication with KNX, configuration with ETS
The term "room operator unit" in this document always refers to all types:
QMX3.P02. P30. P34, P70 und P74.
0.4 Reference documents
The following documents are available at www.siemens.com/gamma-td
[1] Data sheet N1602
[2] Mounting instructions M1602
[3] Word template for labels (QMX3.P02, P37) M1602.1
[4] KNX Standard, Volume 3: System Specifications, Part 7, Chapter 2: Data
Point Types (http://www.knx.org/
)
[5] Service- and Operating software ACS790 (Data sheet N5649)
Use of documents /
Request to the reader
Abbreviations
Naming convention