Technical data

3.14.2 Parameter setting / download via tool
Control parameters can be adjusted via bus either by parameter download during
commissioning or during normal operation with a tool like ACS.
With the ACS tool, the parameters can be changed…
– during commissioning via parameter download (all parameters)
– during normal operation via Popcard (most of the parameters)
Most parameters can be changed during normal operation using the OZW772 web
server or the RMZ792 bus operator unit.
ETS is an engineering tool and can be used for the full commissioning of the RDG
KNX thermostats. Device address, application, and control parameters can be
defined and downloaded via ETS.
• Setting RDG KNX parameters is only supported by ETS4 or higher / ACS
version 5.11 or higher.
• The RDG KNX thermostats (without ETS parameter download) require version
ETS3f or higher / ACS version 5.11 or higher.
Connecting a KNX commissioning / operating tool to the RDG is described in
section 4.2.
ACS
OZW772 Web server,
RMZ792 bus operator
unit
ETS
Notes
Connecting a KNX tool
71 / 102
Siemens RDG100KN, RDG160KN Basic documentation CE1P3191en
Building Technologies Functions 2014-05-23