Technical data

5. Supported KNX tools
5.1 ETS
ETS is an engineering tool. It can be used for the full commissioning of the RDG
KNX thermostats.
The following functions can be realized with ETS4:
– Define and download the physical address
– Define and download the application (plant type, control sequence)
– Set up and download the thermostat's control parameters
– Set up and download group addresses
This basic documentation does not describe how to operate ETS and commission
a device. Refer to the KNX Manual for more details.
Setting RDG KNX parameters is only supported by ETS4 or higher.
ETS4 can be updated online.
5.1.1 Parameter settings in ETS
For setting the parameters, open the project and select a device.
To start the parameter settings, select Edit, then Edit parameters.
• The ETS version 3f or higher can be used to assign the communication objects
to group addresses (S-mode).
• The ETS4 or higher can be used to download the application and parameters.
The application (plant type) and Control Sequence can be adjusted and down-
loaded.
ETS
STOP
Note!
Notes
82 / 102
Siemens RDG100KN, RDG160KN Basic documentation CE1P3191en
Building Technologies Supported KNX tools 2014-05-23