User Manual

ManualsBrandsSiemens ManualsCassette PlayerRDG400

Operating Instructions

RDG400

– the electronic room thermostat that allows you to set the ideal room temperature you want.

The

thermostat satisfies your individual needs in all operating modes: Comfort, Energy Saving and

Protection mode. You can either rely on the factory settings or make adjustments that suit your individual

needs.

Main display

Operating mode

Room

temperature

Heating mode

Room temperature in

degrees Celsius

Electrical heater on

Room temperature in

degrees Fahrenheit

Cooling mode

Button lock active

Comfort mode

Alert indicator

Energy Saving mode

Condensation in the

room

Protection mode:

Protection against frost

Temporary timer

function active

Indicator for selecting

mode

Additional user information

Operating mode button

Protection mode button

Rotary knob

Changing the room temperature

• The setpoint can be adjusted with the rotary knob when Comfort mode is

active

• Turn the rotary knob clockwise (+) to increase, or counterclockwise (-) to decrease

the current room temperature setpoint for Comfort mode

The setting range is from 5...40 °C (41 … 104 °F), unless limited by parameters P09 and P10

(parameter

Settings, see reverse side).

Select

ing Comfort mode

• Press the operating mode button until symbol appears, indicating that

Comfort mode is selected

• In Comfort mode, the thermostat maintains the setpoint which can be adjusted

with the rotary knob

lecting Protection mode

• Press the operating mode button until symbol appears, indicating that

Protection mode is selected

• In Protection mode, the plant stops operating. If the room temperature falls below

8 °C, heating is switched on however to protect the room against frost

The setpoints for Protection mode can be changed by your HVAC installer if desired:

Changes made by installer: Frost protection: ________ °C / °F Heat protection: __________ °C / °F

Selecting

Energy Saving mode

In Energy

Saving mode, the room temperature is maintained at a lower or higher setpoint, thus saving

energy and money.

• When selecting Energy Saving mode, make sure parameter P02 is set to 2

• Press the operating mode button until

appears

• You can change the preselected setpoint by adjusting parameters P11 and P12

(for parameter settings, see reverse side)

Important: The setpoint for Energy Saving mode can be set to OFF. This means that the thermostat is

deactivated! Risk of frost, i.e. no protective heating or cooling function is provided.

Energy saving tips without sacrificing comfort:

• Air out rooms for short periods of time only, but properly, with the windows wide open

• Never allow the room temperature to exceed 21 °C (70 °F) through heating, and to fall below 25.5 °C (78 °F) through

cooling

Button lock

• To lock or unlock the buttons manually, press and hold the right button for 3

seconds. The buttons can be locked or unlocked in this manner if P14 is set to 2

• If P14 is set to 1, the thermostat automatically locks the buttons 10 seconds after

the last adjustment

Summary of content (2 pages)

PAGE 1
s Operating Instructions en RDG400 RDG400 – the electronic room thermostat that allows you to set the ideal room temperature you want. The thermostat satisfies your individual needs in all operating modes: Comfort, Energy Saving and Protection mode. You can either rely on the factory settings or make adjustments that suit your individual needs.
PAGE 2
Temporary timer for extended presence or absence The Comfort and Energy Saving modes can be temporarily extended by 0.5 to 9.5 hours using the temporary timer. 1. To set the temporary timer, press and hold the operating mode button for maximum 3 seconds. While holding the button, turn the rotary knob clockwise or counterclockwise as required. a) Turn the rotary knob clockwise to extend Comfort mode. Display: b) 0....+9:30 Turn the rotary knob counterclockwise to extend Energy Saving mode. Display: 0..