User Manual

3
Smart Infrastructure
A6V11562461_en--_a
2019-09-19
RDS110.R with radiator valve actuator (SSA911.01TH):
● Radiator with valve (SSA911.01TH)
Note: The RDS110.R can control max. 6 valve actuators in parallel, i.e. with the same control
settings.
RDS110.R with wireless receiver (RCR114.1):
● Gas boiler
● Radiator with pump
● Electric floor heating
● Fan with electric heating
● Floor heating with valve
● Floor heating with pump
● Electric radiator
● Electric boiler
● Generic heating device
NOTICE
When selecting the gas boiler application, ensure a hydronic heating is used. The
RDS110.R is not calibrated for use in combination with a gas-fired ducted heating system.
The RDS110.R can control max. 6 receivers in parallel, i.e. with the same control settings.
The RCR114.1 has two relay outputs, one of which is for heating equipment (listed above).
The other relay is available to optionally control a domestic hot water (DHW) boiler,
humidifier or dehumidifier.
The RDS110.R has two multifunctional inputs, optional and configurable for:
● Operating mode switchover contact
– The operating mode can change according to contact status.
● Remote room temperature sensor
– The remote temperature sensor can acquire the current room temperature. If the
sensor input signal is lost, the thermostat controls the room according to the internal
sensor.
● Floor temperature sensor
– The floor heating limitation function prevents the floor temperature from exceeding a
preset value.
● Outside air temperature sensor
– The outside air temperature sensor can acquire outside air temperature information
for display on touch screen.
● Remote humidity sensor
– The thermostat can control a standalone humidifier or dehumidifier. The relative
humidity is measured by the remote humidity sensor or internal humidity sensor.
● VOC and CO
2
sensors
● Condensation monitor
● Universal contact