User Manual

Operating the thermostat on the device
WLAN connection
6
A6V11562455_en
--_a 23 | 60
See the Quick guide for guidance to the setup wizard. You must perform a factory
reset if you want to change the network connection type after you’ve set up the
thermostat following the wizard. Note that a factory reset erases all user data.
See
Changing system setup [➙ 35]
for information about how to perform a factory
reset.
To connect to a network
1. If the thermostat is selected for commercial use, do the following:
– On the Home screen, tap , then tap . The Advanced Settings page
displays.
– If required, enter your administrator password.
– Tap > , and then wait for the thermostat to discover the networks
nearby.
2. If the thermostat is selected for home use, do the following:
– On the Home screen, tap , and then tap until the Settings page displays.
– Tap > > , and then wait for the thermostat to discover the networks
nearby.
3. Tap your desired network. If necessary, tap or to scroll through the
networks to select one.
4. For secured networks, enter the relevant password, and then tap Connect.
Note: For more information about the administrator password, see Creating an
administrator password [➙ 25].
To add a network manually
1. If the thermostat is selected for commercial use:
– On the Advanced Settings page, tap > , and then tap to scroll down
to find and tap
Add Network.
2. If the thermostat is selected for home use:
– On the Settings page, tap > > , and then tap to scroll down to find
and tap
Add Network.
3. Enter the Network name (SSID) information.
4. To select a security type, tap the Security field.
5. Tap Connect.
6. If prompted, enter the relevant password, and then tap Connect.
To configure your current network settings
1. If the thermostat is selected for commercial use:
– On the Advanced Settings page, tap > . Your current network displays
on the screen.
2. If the thermostat is selected for home use:
– On the Settings page, tap > > . Your current network displays on the
screen.
3. Tap Network Settings. The default DHCP (Dynamic host configuration protocol)
setting page displays on the screen.
– Tap to scroll through and view other network DHCP settings like
Preferred DNS.
– Note: To customize the current network settings, tap Manual, select a field,
or tap or to scroll to the desired field, and then enter a new setting.