User Manual

Appendices
Frequently asked questions
11
56
| 60 A6V11562455_en--_a
11.1.6 Can I change the Green leaf settings?
No, you can’t. The Green leaf settings are defined by the system and are not
changeable from user side.
For more information about Green leaf, see Green leaf indication.
11.1.7 Where can I check the current time on the thermostat?
You can check the time under Advanced Settings > Time.
● If the thermostat has WLAN connection now and hasn't been powered off for
more than three minutes, the time is displayed validly and correctly.
● If the thermostat has WLAN connection now but has been powered off for more
than three minutes, the time may be displayed invalidly temporarily but will be
synchronized with the server within 24 hours. Once the synchronization is
done, the time will be displayed correctly again.
● If the thermostat doesn't have WLAN connection now, see more information in
this section: Can the thermostat display the time correctly if there is no WLAN
connection? [➙ 56]
NOTE: To display the time correctly, it is important to set the time zone correctly.
See
Changing a time zone [➙ 27] for more information.
11.1.8 Can the thermostat display the time correctly if there is no
WLAN connection?
If there is no WLAN connection, the thermostat displays the time correctly only
when:
● The thermostat connected to a WLAN network once and could display time
correctly.
● The thermostat hasn't been powered off for more than three minutes.
Lacking either of the above conditions may result in incorrect time display.
11.1.9 Can I set the time manually?
No, you can’t. The thermostat gets the time automatically after you've added the
thermostat to a WLAN network and set a correct time zone.
11.1.10 Why is the time displayed incorrectly even though the
thermostat is added to a WLAN network?
Maybe it is because the synchronization with the server hasn't started yet, or
because the time zone is not selected correctly. Normally the server synchronizes
the time at a fixed time of each day.
11.1.11 What does the Kick cycle function mean?
It means whether to run a constantly idle pump or valve periodically to protect it
from seizure. If one of the following equipment is selected as the heating system,
Kick cycle is available and you can decide whether to activate the function or not.
● Radiator with valve
● Radiator with pump
● Floor heating with valve
● Floor heating with pump
For more information about equipment selection and activation of the Kick cycle
function, see
Changing system setup [➙ 35]. For more information about the
interval of running the pump or valve forcibly, see Parameter 24 in Managing
application settings [➙ 27].