User Manual

A6V11562445_en--_a 5 / 91
en
Connecting the thermostat to a wireless receiver (RCR114.1) or valve actuator (SSA911.01TH)
1. Power up RCR114.1 (via wire) or SSA911.01TH (with battery).
2. On the thermostat Home screen, tap , then and . The
Advanced settings screen displays.
3. Enter the administrator password when prompted.
4. Tap and then .
5. Tap Pair new devices, then follow the on-screen instructions to
press the push button on RCR114.1or SSA911.01TH. Depending
on your set-up, establishing the connection may take some time.
Notes:
a. Set the DIP switch on RCR114.1 to configure the device as a
relay or repeater before connecting it to the thermostat.
b. Add a repeater (RCR114.1) if the connection fails due to low
signal strength (distance or blockades (walls, etc.)).
c. The thermostat can only connect to one heating system type
at a time – so it cannot simultaneously control a wireless relay
and a valve actuator.
d. The thermostat can control up to 6 wireless relays or up to 6
valve actuators.
Overview of connected devices
1
Wireless repeater (RCR114.1 only)
5
Device not reachable or
communication failure
2
Relay or actuator (RCR114.1 or
SSA911.01TH)
6
Low battery
(SSA911.01TH only)
3
Signal strength of connected
device
7
Tap to view all devices
4
Remove device
8
Add more devices