System Manual Part 1
Table Of Contents
- SIMATIC RF200
- Table of contents
- 1 Introduction
- 2 Safety notes
- 3 System overview
- 4 Planning the RF200 system
- 4.1 Fundamentals of application planning
- 4.1.1 Selection criteria for SIMATIC RF200 components
- 4.1.2 Transmission window and read/write distance
- 4.1.3 Width of the transmission window
- 4.1.4 Impact of secondary fields
- 4.1.5 Permissible directions of motion of the transponder
- 4.1.6 Operation in static and dynamic mode
- 4.1.7 Dwell time of the transponder
- 4.1.8 Communication between communication module, reader and transponder
- 4.2 Field data of transponders and readers
- 4.3 Installation guidelines
- 4.4 Further information
- 4.1 Fundamentals of application planning
- 5 Readers
- 5.1 SIMATIC RF210R
- 5.2 SIMATIC RF210M
- 5.3 SIMATIC RF220R
- 5.4 SIMATIC RF240R
- 5.5 SIMATIC RF250R
- 5.6 SIMATIC RF260R
- 5.7 SIMATIC RF280R
- 5.8 SIMATIC RF290R
- 6 Antennas
Planning the RF200 system
4.3 Installation guidelines
SIMATIC RF200
74 System Manual, 07/2017, J31069-D0227-U001-A9-7619
4.3.4.6
RF280R
The RF280R can be flush-mounted in metal. Please allow for a possible reduction in the field
data values. To avoid reduction, the distance a should be ≥ 20 mm.
Figure 4-14 Metal-free area RF280R
Table 4- 31 Reduction of field data due to metal, range as %: Transponder and RF280R
Transponder
Reader without
metal direct
metal influence
Reader on
metal (metal
plate)
Flush-mounted
in metal (20 mm
all-round)
MDS D100
1)
Without metal
100
95
80
On metal; distance 20 mm
65
60
55
Flush-mounted in metal;
distance all round 20 mm
2)
55 50 45
MDS D124
1)
Without metal
100
95
90
On metal; distance 15 mm 95 90 85
Flush-mounted in metal;
distance all round 20 mm
2)
70 65 50
MDS D126
1)
Without metal 100 90 80
On metal; distance 25 mm
80
75
70
Flush-mounted in metal;
distance all round 50 mm
3)
75 65 65
MDS D139
1)
Without metal
100
90
75
On metal; distance 30 mm
95
85
70
Flush-mounted in metal;
distance all round 100 mm
4)
90 80 70
MDS D160
1)
Without metal
100
95
90
On metal; distance 10 mm
2)
85
85
80
MDS D165
Without metal
100
90
80
On metal; distance 25 mm
4)
80
75
70
MDS D200
1)
Without metal
100
90
80
On metal; distance 20 mm
80
75
70