Readers 5.2 SIMATIC RF610R 5.2 SIMATIC RF610R 5.2.1 Description 5.2.1.1 Overview The SIMATIC RF610R is a stationary reader in the UHF frequency band with an integrated antenna. The maximum transmit power is 400 mW, the radiant power of the internal antenna is 200 or 250 mW ERP / 400 mW EIRP. The interfaces (Ethernet, power supply) are located on the lower front edge. These interfaces can be used to connect the reader to the power supply and a PC for parameter assignment.
Readers 5.2 SIMATIC RF610R 5.2.1.
Readers 5.2 SIMATIC RF610R 5.2.1.3 Pin assignment of the power supply interface (X80 24VDC) Table 5- 4 Pin assignment of the RS422 interface (reader end) View of interface (M12 socket, 8-pin) Pin Wire colors Assignment White + 24 V Brown - Tx 3 Green 0V 4 1) Yellow + Tx 1 2 5 1) Gray + Rx Pink - Rx 7 -- Unassigned 8 -- Earth (shield) 1) 6 1) 1) These pins are not required if the reader is operated via Ethernet.
Readers 5.2 SIMATIC RF610R NOTICE For long cables: Adapt the power supply and transmission speed Note that even with long cables, the supply voltage of 24 VDC must always be guaranteed. Note also that the transmission speed on the serial interface must, if necessary, be reduced. SIMATIC standard cables (e.g. 6GT2891-4FN10) have a loop resistance of 160 mOhm / meter. This results in a voltage drop of 0.8 volts on the 24 V cable for every 10 meters of connecting cable and with a power requirement of 500 mA.
Readers 5.2 SIMATIC RF610R Dense Reader Mode (DRM) The readers can also interfere with each other (secondary fields), if the channels (Reader TX, Transponder TX) overlap. In order to prevent a transponder channel overlapping with a reader channel, we recommend that the Dense Reader Mode (DRM) is used. Note Protective cap If you only use the internal antenna of the reader, we recommend that you close the external, unused antenna connector on the reader using the protective cap.
Readers 5.
Readers 5.2 SIMATIC RF610R Overview of the antenna parameters Table 5- 6 Maximum linear electrical aperture angle at 865 MHz: Polarization (circular) Azimuth section 100° Elevation section 100° Typical antenna gain in the frequency band 865 to 868 MHz -1 dBi Antenna axis ratio 2 dB You will find more information on the antennas in the section "Guidelines for selecting RFID UHF antennas (Page 51)".
Readers 5.
Readers 5.2 SIMATIC RF610R Overview of the antenna parameters Table 5- 7 Maximum linear electrical aperture angle at 915 MHz: Polarization (circular) Azimuth section 100° Elevation section 100° Typical antenna gain in the frequency band 902 to 928 MHz 0 dBi Antenna axis ratio 2 dB You will find more information on the antennas in the section "Guidelines for selecting RFID UHF antennas (Page 51)". 5.2.2.
Readers 5.2 SIMATIC RF610R 5.2.4 Configuration/integration An Ethernet interface is available for integrating the device into system environments/networks. RF610R can be configured via the Ethernet interface and with direct connection to the PC.
Readers 5.2 SIMATIC RF610R 5.2.5 Technical specifications Table 5- 8 Technical specifications of the RF610R reader 6GT2811-6BC10-xAA0 Product type designation SIMATIC RF610R Radio frequencies Operating frequency • ETSI • 865 to 868 MHz • FCC • 902 to 928 MHz • CMIIT • 920 to 925 MHz Transmit power • ETSI • 3 ... 400 mW • FCC • 3 ... 400 mW • CMIIT • 3 ...
Readers 5.2 SIMATIC RF610R 6GT2811-6BC10-xAA0 Typical transmission time per byte • Write access • 2 ms • Read access • 0.15 ms Supply voltage 24 VDC (20 ... 30 VDC) Maximum permitted current consumption 0.3 A 1) Current consumption (on standby), typical • 20 V input voltage on the reader • 200 mA / 4 W • 24 V input voltage on the reader • 170 mA / 4.1 W • 30 V input voltage on the reader • 150 mA / 4.
Readers 5.2 SIMATIC RF610R 6GT2811-6BC10-xAA0 Design, dimensions and weight Dimensions (W × H × D) 140.5 × 133 × 45 mm Weight 370 g Type of mounting VESA 100 4x screws M4 (≃ 1.5 Nm) Operation indicator 6 LEDs Status display 1 LED (enclosure, all-round) Standards, specifications, approvals Proof of suitability EN 301 489-1 V2.2.0 / EN 301 489-3 V2.1.1 / EN 302 208 V3.1.1 FCC CFR 47, Part 15 section 15.
Readers 5.2 SIMATIC RF610R 5.2.6 Figure 5-6 Dimension drawing Dimension drawing RF610R All dimensions in mm (± 0.
Readers 5.2 SIMATIC RF610R 5.2.7 Certificates and approvals 5.2.7.1 CE mark Note Marking on the readers according to specific approval The certificates and approvals listed here apply only if the corresponding mark is found on the readers. Table 5- 9 6GT2811-6BC10-0AA0 Labeling Description Conformity with the RED directive 2014/53/EU Conformity with the RoHS directive 2011/65/EU 5.2.7.
Readers 5.2 SIMATIC RF610R 5.2.7.3 FCC information Siemens SIMATIC RF610R (FCC): 6GT2811-6BC10-1AA0 FCC ID: NXW-RF610R This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
