User Manual

Siemens Industry, Inc,
Building Technologies Division
P/N 315-033230-4
INTRODUCTION The Models RL-HC (round plate) and RL-HW (rectangular plate) remote lamps from
Siemens Industry, Inc., work with HFP-11 / HFPT-11 / HFPO-11 and SFT-11* / SFPT-11*
/ SFPO-11* detectors. The red LED on the RL-HC or RL-HW lights when its associated
detector goes into alarm.
*SFP-11, SFPT-11 and SFPO-11 detectors are approved for use in Canada only.
INSTALLATION The remote lamp may be placed up to 25 feet away from the detector using 14-18
gauge wire.
• Use a single-gang switch box (user supplied) for mounting the RL-HW; Use a
4 inch octagonal conduit box (user supplied) for mounting the RL-HC. Make
connections to the RLH as shown in Figure 1.
• The RL-HC/RL-HW TB2 and TB3 are polarity insensitive.
Figure 1
RL-HC/RL-HW Wiring Diagram
TB3
TB1
TB2
TB2
TO DETECTOR (5 OR 6)
TO DETECTOR (1a)
TO DETECTOR (6 OR 5)
RLH
NOTE:
If TB2 is connected to
Detector (5), TB3 should be
connected to Detector (6).
Likewise, if TB2 is con-
nected to Detector (6), TB3
should be connected to
Detector (5).
Remote Lamp Ceiling Mount / Remote Lamp Wall Mount
Installation Instructions
Models RL-HC and RL-HW