User Manual

6.2.4 Fault messages
The following fault messages are generated during violation (above and below) if
the corresponding times for "Event duration min/max" or "Event cycle min/max" are
greater than 0.
You must acknowledge these fault messages.
No. Text Effect
9111 [Logger 1] on before cycle min Fault priority as set;
must be acknowledged and reset.
9112 [Logger 1] on after cycle max Fault priority as set;
must be acknowledged and reset.
9113 [Logger 1] off before dur min Fault priority as set;
must be acknowledged and reset.
9114 [Logger 1] off after dur max Fault priority as set;
must be acknowledged and reset.
9121 [Logger 2] on before cycle min Fault priority as set;
must be acknowledged and reset.
9122 [Logger 2] on after cycle max Fault priority as set;
must be acknowledged and reset.
9123 [Logger 2] off before dur min Fault priority as set;
must be acknowledged and reset.
9124 [Logger 2] off after dur max Fault priority as set;
must be acknowledged and reset.
9131 [Logger 3] on before cycle min Fault priority as set;
must be acknowledged and reset.
9132 [Logger 3] on after cycle max Fault priority as set;
must be acknowledged and reset.
9133 [Logger 3] off before dur min Fault priority as set;
must be acknowledged and reset.
9134 [Logger 3] off after dur max Fault priority as set;
must be acknowledged and reset.
9141 [Logger 4] on before cycle min Fault priority as set;
must be acknowledged and reset.
9142 [Logger 4] on after cycle max Fault priority as set;
must be acknowledged and reset.
9143 [Logger 4] off before dur min Fault priority as set;
must be acknowledged and reset.
9144 [Logger 4] off after dur max Fault priority as set;
must be acknowledged and reset.
Fault messa
ges
6.2.5 Troubleshooting
 Changing the current data or time during event logging may result in premature
triggering of a fault message.
Notes
 After changing the extra configuration in the event logger, previous logs are
deleted when the extra configuration is closed.
 No event logging takes place if "Limit value on" = "Limit value off".
48 / 216
Siemens Switching and monitoring device RMS705B CE1P3124en
Building Technologies Data acquisition 01.04.2010