Assortment / System Description

Configuration diagram RMS705B and function blocks

Basic type S represents the empty application for free configuration. In the

configuration diagrams, the input and output functions (that is, their internal

signals) are connected to the inputs and outputs.

The following table gives a brief description of all function blocks integrated in the

RMS705B switching and monitoring device. The large number of function blocks

clearly demonstrate the universal use of the product.

Inputs Functions

N.X1

SIGNAL Y

N.X1

SIGNAL Y

- Universal input for entry of input identifier and units: °C, %, g/kg, kJ/kg, W/m², m/s, bar, mbar, Pa,

ppm, display 000.0 (with 1 decimal place), 0000 (without decimal place)

- Input for: LG-Ni1000, 2x LG-Ni1000 (averaging), T1, Pt1000, DC 0…10 V, digital (potential free

contacts), pulses up to 25 Hz (mechanical signal sources, Reed contact), 100 Hz (el. signal sources)

- Each input can be assigned a name (e.g. OT for outside temperature)

- Connection of outside temperature sensor to terminals or outside temperature via the KNX bus

- Special identifiers: Outside temperature, remote setpoint adjuster (internal connections)

Calendar Functions

Calendar

- Holiday and special day input: Digital input for holidays (selectable room operating mode)

or special day (special day program of time switch)

- Selection whether holidays/special day zone shall operate autonomously, as a slave (holidays/

special day information via KNX bus) or master (sends holidays/special day information via the

KNX bus)

Basic type S

Function blocks