Basic Documentation

16/332
Siemens Universal controllers RMU710B, RMU720B, RMU730B CE1P3150en
Building Technologies Operation 03.10.2011
2 Operation
Synco™ 700 devices may only be operated by staff who have been instructed by
Siemens Building Technologies or their delegates and whose attention has been
drawn to potential risks.
2.1 Operation without operator unit
The following operating elements on the controller and extension module can be
used with the operator unit:
3140Z02
1
234
3140Z03
5
Universal controller Extension module
1 LED (Run) for indicating the device’s operating state:
LED lit: Power on, no fault in the application / periphery
LED off: No power or fault in the application / periphery
2 Button "
" with LED (red) to display fault status message and its
acknowledgement:
LED flashes: Fault status message ready to be acknowledged
LED lit: Fault status message pending, but not yet reset
LED off: No fault status message
Press button: Acknowledge fault or reset
3 Programming button (Prog) for assigning the device address in KNX system
mode (tool required)
4 Programming LED (Prog) to display programming process, with meaning:
LED lit: LED remains lit until addressing is completed
5 LED (Run) for monitoring power supply and addressing; with the following
meaning:
LED lit: Power on, addressing successful
LED flashes: Power on, controller still has not valid KNX address
LED off: No power
Key