Single-Board Fast Ethernet Switch Operators User Manual

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
42 A50010-Y3-C150-2-7619
To disable password encryption, use the following command.
Command Mode Description
no service password-encryption Global Disables password encryption.
4.1.3 Changing Login Password
To configure a password for created account, use the following command.
Command Mode Description
passwd [NAME] Global Configures a password for created account.
The following is an example of changing password.
SWITCH(config)# passwd Siemens
Changing password for Siemens
Enter the new password (minimum of 5, maximum of 8 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:junior95
Re-enter new password:junior95
Password changed.
SWITCH(config)#
The password you are entering won’t be seen in the screen, so please be careful not to
make mistake.
4.1.4 Management for System Account
4.1.4.1 Creating System Account
For the hiD 6615 S223/S323, the administrator can create a system account. In addition,
it is possible to set the security level from 0 to 15 to enhance the system security.
To create a system account, use the following command.
Command Mode Description
user add NAME DESCRIPTION Creates a system account.
user add NAME level <0-15>
DESCRIPTION
Global
Creates a system account with a security level.
The account of level 0 to level 14 without any configuring authority only can use exit and
help in Privileged EXEC View mode and cannot access to Privileged EXEC Enable mode.
The account with the highest level 15 has a read-write authority.
i
!