User manual

31
0 CLIR not provisioned
1 CLIR provisioned
2 Unknown (no network)
Application to GSM AT+CLIR=2
GSM to application OK command valid
Application to GSM AT+CLIR? Ask for current functionality
GSM to application +CLIR: <n>,<m>
OK
"n" and “m” as defined above
7.4.6 Calling line identification presentation +CLIP
This command allows control of the calling line identification presentation supplementary service :
AT+CLIP=<n>
<n> : parameter sets/shows the result code presentation in the TA
0 Disable
1 Enable
<m> : parameter shows the subscriber CLIR service status in the network
0 CLIP not provisioned
1 CLIP provisioned
2 Unknown (no network)
Application to GSM AT+CLIP=1 Enable CLIP
GSM to application OK CLIP is enabled
Application to GSM AT+CLIP? ask for current functionality
GSM to application +CLIP: <n>,<m>
OK
"n" and “m” as defined above
GSM to application RING
+CLIP: +49897220,145
incoming call
Application to GSM AT+CLIP=0 Disable CLIP
GSM to application OK Command valid
7.4.7 Connected line identification presentation +COLP
This command allows control of the connected line identification presentation supplementary service:
AT+COLP=<n>
<n> : parameter sets/shows the result code presentation status in the TA
0 Disable
1 Enable
<m> : parameter shows the subscriber COLP service status in the network
0 COLP not provisioned
1 COLP provisioned
2 Unknown (no network)
Application to GSM AT+COLP=1 Activate COLP
GSM to application OK command valid
Application to GSM AT+COLP? ask for current functionality
GSM to application +COLP: 1,<m>
OK
<m> as defined above
Application to GSM ATD+49897220; outgoing call
GSM to application +COLP: +49897220,145
OK