Specifications

Setting Up Communications Hardware and Network Communications
7-12
S7-200 Programmable Controller System Manual
C79000-G7076-C233-01
6. Click the Local Connection tab. See Figure 7-8.
7. In the Local Connection tab, select the COM port to which your PC/PPI cable is
connected. If you are using a modem, select the COM port to which the modem
is connected and select the Use Modem check box.
8. Click the “OK” button to exit the Setting the PG/PC Interface dialog.
"
Cancel
Help
OK
Interfaces
Install...
Setting the PG/PC Interface
Access Point of Application:
Micro/WIN -->PC/PPI cable (I
(Standard for Micro/WIN)
Interface Parameter set used:
PC/PPI cable (PPI)
MPI-ISA on board (MPI)
MPI-ISA on board (PPI)
MPI-ISA Card (PROFIBUS)
PC Adapter (MPI)
PC Adapter (PROFIBUS)PC/
PPI cable (PPI)
Properties...
Delete
Copy...
(Assigning Parameters to a PC/PPI Cable
for a PPI Network)
Cancel HelpOK
Properties - PC/PPI cable (PPI)
PPI
Default
Local Connection
COM port:
Use Modem
1
Access Path
Figure 7-8 Properties - PC/PPI Cable (PPI) Dialog, Local Connection Tab
Configurations Using a PC with an MPI or CP Card: Multiple-Master Network
Many configurations are possible when you use a multipoint interface card or
communications processor card. Either card provides a single RS-485 port for
connection to the network using an MPI cable. You can have a station running the
STEP 7-Micro/WIN 32 programming software (PC with MPI or CP card, or a
SIMATIC programming device) connected to a network that includes several
master devices. (This is also true of the PC/PPI cable if you have enabled multiple
masters.) These master devices include operator panels and text displays (TD 200
units). Figure 7-9 shows a configuration with two TD 200 units added to the
network.