Specifications

Getting Started with an S7-200 Programming System
3-6
S7-200 Programmable Controller System Manual
C79000-G7076-C233-01
How Do I Verify the Default Parameters for My Interface?
You can verify the default parameters for your interface by following the steps
below:
1. In the STEP 7-Micro/WIN 32 window, click the Communications icon, or select
View > Communications from the menu. The Communications Setup dialog
box appears.
2. In the Communications Setup dialog box, double-click on the icon for the
PC/PPI cable. The Setting the PG/PC Interface dialog box appears. See
Figure 3-3.
3. Select the “Properties” button. The Properties dialog box for the interface
appears (see Figure 3-4). Check the properties to ensure that they are correct.
The transmission rate should be 9,600 baud.
4. For help in changing the default parameters, see Section 7.3 in Chapter 7.
Note
If the hardware that you are using does not appear on the list shown in Setting
the PG/PC Interface dialog box, then you must install the correct hardware. See
Installing and Removing Interfaces in Section 7.2.