Specifications

Getting Started with an S7-200 Programming System
3-7
S7-200 Programmable Controller System Manual
C79000-G7076-C233-01
Mode PC/PPI cable (COM 1)
Communications Links
Double click the icon representing the PLC
you
wish to communicate with.
Double click the module icon to change to
communication parameters.
Double click the modem icon to setup the
modem parameters or dial to start modem
communications.
Communications Setup
Communication Parameters
Module: PC/PPI cable (COM 1)
Protocol: PPI
Local Address: 0
Remote Address: 2
Transmission Rate: 9.6 bps
"
Cancel
Help
OK
Interfaces
Install...
Access Path
Access Point of Application:
Micro/WIN -->PC/PPI cable (PPI)
(Standard for Micro/WIN)
Interface Parameter set used:
PC/PPI cable (PPI)
MPI-ISA on board (MPI)
MPI-ISA on board (PPI)
MPI-ISA Card (PROFIBUS)
PC Adapter (MPI)
PC Adapter (PROFIBUS)PC/
PPI cable (PPI)
Properties...
Delete
Copy...
(Assigning Parameters to a PC/PPI Cable
for a PPI Network)
PC/PPI
cable
Address: 0
Setting the PG/PC Interface
Figure 3-3 Setting the PG/PC Interface Dialog Box