Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1
100
Values Indicate
***3 C
***4 D
***5 E
***6 F
***7 Pause
***8 Hookflash
***0 Clears the field entry
2.7.3 Using the Teleparameter Feature to Adjust the System
Setup
You can use the Teleparameter feature to adjust the system setup at any time. It is not
necessary to bring down the system to make modifications. To use the Teleparameter feature
to adjust information, follow steps 1 through 4 in the procedure in section 2.7.1.2. For
specific parameters you can adjust, refer to section 2.7.1.2. For detailed information, refer to
the Installation and Maintenance Manual.
Note: If you enter a parameter number for a parameter that affects a particular
box, the system prompts you to enter the Item number. The Item number
identifies the particular box in which you want to change the parameter. At
the Item number prompt, enter the number of the box.
Note: Refer to section 2.7.2 for information on values you can specify for certain
parameters and for information on adjusting parameters in the VM.CFG file.
For detailed information on each field of System Information or Box Setup
screens, refer to the Installation and Maintenance Manual.
Be advised that many day-to-day modifications that must be made to the system (adding
mailboxes, changing system greetings, making call routing modifications) can be done by
calling into the supervisor mailbox and selecting options from the Supervisor menu. By
using Supervisor menu options, you do not need to refer to specific parameter numbers and