Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

2. System Setup Instructions

The Lite system contains a default database with a setup configuration that allows the Lite

system to efficiently perform fundamental call processing tasks with minimal system

adjustments by the installing technician. This default database configuration includes 2 pre-

defined classes of service (0 and 7), 1 supervisor mailbox (mailbox 70), and 3 Routing

boxes—800, 801, 821. Information provided in this document explain how these pre-set

defaults function on the Lite system.

As you proceed through these setup instructions, you may decide to make adjustments to

specific information relating to the default setup. You may even decide to set up the other 2

available Routing boxes to perform additional call routing tasks. As you make any changes,

keep in mind that we urge you to maintain the initial general configuration of Routing boxes

800, 801, and 821, class of service 7, and supervisor mailbox 70. This configuration allows

the Lite system to efficiently perform fundamental call processing tasks. Maintaining it helps

both you, the technician, and Lite system technical support to efficiently service the system

and resolve any call processing issues. For these reasons we urge you not to deviate from this

general system setup default configuration.

Information on setting up and using box types other than Routing boxes and mailboxes is

provided in the Installation and Maintenance Manual.

Note: Section 2.6 provides an overview of the default database setup shipped on

Lite system units.

2.1 Available System Setup Techniques

There are two techniques you can use to set up Lite systems:

• Attach a laptop to the Lite system unit and use the program’s screen interface to run the

System PBX Setup utility then complete System Information and Box Setup screens