Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1
6
• Call into the Lite system and use the Teleparameter feature to run the System PBX Setup
utility then enter parameter codes and corresponding values to set up system and box
information
This document provides instructions for using either system setup technique.
Technicians who have experience setting up Corporate Office, Small Office, or Lite systems
may prefer to use the Teleparameter feature to quickly make modifications and get the Lite
system up and running at the customer’s site. Be advised, however, that since this technique
involves inputting codes that represent system parameters and corresponding values to which
parameters are to be set, it is a bit more difficult to use effectively if you are unfamiliar with
setting up Corporate Office, Small Office, or Lite systems. For this reason, we recommend
that technicians unfamiliar with Corporate Office, Small Office, or Lite systems attach a
laptop to the PC and use the instructions provided here to complete all necessary system setup
steps through the screen interface.
Note: If you choose to set up the system using the Teleparameter feature, be sure
to first review section 2.5.6.2 and 2.6 so you clearly understand the setup of
the default database included on the Lite system unit.
Note that if you choose to initially set up the system by connecting it to a laptop and using the
screen interface, you can later make additional modifications by simply calling into the Lite
system and using options on the Supervisor menu (see section 3) or using the Teleparameter
feature (see section 2.7.2).
2.2 Preparing for System Setup
To install, set up, and maintain a Lite system voice processing system, you need the
following equipment:
Equipment Needed
• Lite system unit
• Portable diskette drive
Should an unusual situation arise, it may be necessary for you to service the Lite