Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1
23
2.5.3 Completing the First Time Setup Procedure
Once you connect the Lite system to the phone system and access the Lite system using a
laptop computer, you are ready to begin customizing the system. Customizing the system
involves:
• Running the PBX Setup utility
• Specifying System Information
• Specifying Routing Box and Mailbox Information
2.5.4 Running the PBX Setup Utility
The Lite system voice processing software is pre-installed on the Lite system unit before it is
shipped to you. You must, however, run the PBX Setup utility so you can configure certain
installation parameters for each specific customer’s site.
On Debut units, you must run the PBX Setup utility using the teleparameter feature. See
section 2.7.1 and section 2.7.1.1 for procedures. Once you run the utility, continue with
section 2.5.5 for information on specifying system information.
On Small Office Lite systems you can run the PBX Setup utility through the screen interface
or using the teleparameter feature discussed in section 2.7.1. To run the utility through the
screen interface, use the following procedure.
1. Make the Lite system unit hard disk the current drive, by typing C: then pressing
<Enter>.
2. To switch to the VM directory, type CD\VM then press <Enter>.
3. To invoke the Install program, type INSTALL then press <Enter>.
4. When the main Install menu displays, use the ↓ key to highlight FIRST TIME SETUP then
press <Enter>.
5. When prompted, type C:\VM then press <Enter> to indicate the directory in which the
Lite system is installed.