Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

• Press 2 to have the system voice the mailbox owner’s currently active greeting to the

called party.

• Press 3 to send the calling party to the destination selected in the IF CALLER

CHOOSES OTHER OPTIONS field on Page 2 of the mailbox’s Mail Box setup screens.

• Press 4 plus a greeting number (0 through 9) to play the selected greeting to the

caller, provided that the greeting has been recorded.

• Press 5 plus any valid box number to send the calling party to that box, where the call

is treated as would any other call to that box.

• Press 6 to accept the call. The parties are connected, but the Lite system remains

connected to the call and records the conversation. The recording is stored as a

message in the called party’s mailbox (provided the host telephone system allows

conferencing on voice mail ports).

(With the Screen transfer type option, the Lite system can perform call queuing if the

extension is busy.)

4. Press <Enter> to move the cursor to the TO: field, and confirm the letter X displays in this

field. This entry instructs the Lite system to transfer calls to the extension number that

matches the box number.

5. Press <Enter> to move the cursor to the CURRENTLY ENABLED field. Verify this field is

set to Yes.

6. Press <Enter> to move the cursor to the TRANSFER SCHEDULE field. Verify this field is

set to Always.

7. Press <Enter> to move the cursor to the SEQUENCE TO TURN ON MESSAGE WAITING

LAMP field. The entries displayed in this field were set during program setup and should

be sufficient. Review the settings shown, and make any changes you feel are necessary.

For details, refer to the phone documentation and technical bulletin for the phone system.