Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1
49
The pager number you enter can contain the digits 0 through 9, star (*), pound (#), and
the following special characters:
Character Use
P Use pulse (also known as ‘rotary’) dialing.
T Use tone dialing (the default).
, Short pause (duration can be changed in Technical Information
screen. Default is one second).
% Medium pause (equal in length to 4 commas).
L Long pause (equal in length to 8 commas).
! Hookflash.
N No progress tones (must be last character). The Lite system
ignores all call progress tones during the course of the call. When
it has finished dialing, the system immediately assumes that the
pager system has answered.
[ ] Enclosing the number in brackets prevents the mailbox owner from
being able to call in and change the number.
{} Specifies a line group is to be used (for example, {A}555-1212
indicates “choose any line in line group A, and dial the number
555-1212”).
any other
character
Can be used for punctuation and is ignored.
PAGER TYPE
The Lite system supports both Tone and Digital pagers in this section of the mailbox
programming. Specify here which type of pager the mailbox owner has (Digital, Tone or
None).
When a caller asks the Lite system to page a mailbox owner, the Lite system looks for a
free line on which to call the paging service. If no lines are free to make the call, the Lite
system queues the request and re-tries every 10 seconds for approximately 10 minutes.