Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

Character Use

received a DTMF digit (1 for Yes, anything else for No), by the end of the

announcement cycle(s), it assumes that it is talking to an answering

machine, and proceeds to play each new message in turn.

V Voice pager. This must be the last character in the telephone number.

Details of voice pager programming are found later in this section.

I Internal (must be the first character). Overrides the INTERNAL parameter (in

the configuration file VM.CFG) and treats this number as an internal call

regardless of the number of digits. The Lite system does not dial the

sequence specified in the General Information / Digits To Get A Line On

External Call field.

E External (must be the first character). Overrides the INTERNAL parameter

(in the configuration file VM.CFG) and treats this number as an external call

regardless of the number of digits. The Lite system dials the sequence

specified in the General Information / Digits To Get A Line On External Call

field.

N No progress tones (must be the last character). The Lite system ignores all

call progress tones during the course of the call.

any other

character

Can be used for punctuation and is ignored.

The owner of a mailbox can call in and remotely change the first Message Notification

number, but cannot use or modify special characters.

REPEAT

Enter the number of successful calls to each telephone number. A successful call is

generally defined as one where the Lite system has seized an available line port, dialed

the number, and detected an answer. If the call is not successful (for example, the called

number was busy) the Lite system automatically re-tries every few seconds up to twenty

times.

INTERVAL

If the Repeat field contains a number greater than 1 or there are additional Call number

sequences, enter the interval (in minutes) between calls to this number and/or the interval

before proceeding to the next Call number sequence.