Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

codes that identify each parameter you want to change and the new value to which you want

to set the parameter. The screen illustrations and parameter value table provided in this

section indicate the parameters and their associated codes.

Technicians who have experience setting up Corporate Office, Small Office, or the Lite

systems may prefer to use the Teleparameter feature to quickly make modifications and get

the Lite system up and running at the customer’s site. Be advised, however, that since this

technique involves inputting codes that represent system parameters and corresponding

values to which parameters are to be set, it is a bit more difficult to use effectively if you are

unfamiliar with setting up Corporate Office, Small Office, or Lite systems. For this reason,

we recommend that technicians unfamiliar with Corporate Office, Small Office, or Lite

systems attach a laptop to the PC and use the instructions provided in the previous sections to

complete all necessary system setup steps.

Note: If you choose to set up the system using the Teleparameter feature, be sure

to first review section 2.5.6.2 and section 2.6 so you clearly understand the

setup of the default database included on the Lite system unit.

2.7.1 Using the Teleparameter Feature to Set up a New

System

2.7.1.1 Running the PBX Setup Utility

The Lite system voice processing software is pre-installed on the Lite system unit before it is

shipped to you. You must, however, run the PBX Setup utility so you can configure certain

installation parameters for each specific customer’s site. Use the following procedure to run

this utility by calling into the system over the telephone:

1. From a telephone, call into voice mail and log into supervisor mailbox 70. Note that the

default password for the mailbox is the same as the mailbox number, 70.

2. The Lite system tutorial session starts. Complete the tutorial. When prompted to record

the name and greeting, you may elect to identify this as the supervisor mailbox. When

changing the password, be sure to inform the system supervisor of the number you select.