Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

Note: If you enter a parameter number for a parameter that affects a particular

box, the system prompts you to enter the Item number. The Item number

identifies the particular box in which you want to change the parameter. At

the Item number prompt, enter the number of the box.

Note: Refer to section 2.7.2 for information on values you can specify for certain

parameters and for information on adjusting parameters in the VM.CFG file.

For detailed information on each field of Box Setup screens, refer to the

Installation and Maintenance Manual.

2.7.1.5 Creating Other Box Types and Adjusting Information

To create other types of boxes, you must first follow the procedures presented earlier in this

document to connect a laptop computer to the Lite system unit and access Box Information

setup screens. Once you create the boxes using this technique, you can make detailed

modifications to the box setups using the Teleparameter feature. To use the Teleparameter

feature to adjust information in boxes already created on the system, follow steps 1 through 4

in the procedure in section 2.7.1.2. For specific parameters you can adjust, refer to section

2.7.2. For detailed information on each field of these screens, refer to the Installation and

Maintenance Manual.