Data Sheet for Product
s Canada Limited
Building Technologies Division
Specifications
– High-fidelity speaker appliances are Siemens Series ‘SEH’ HiFi Speakers, and the
speaker-strobe appliances are Siemens Series ‘SEH’ HiFi Speaker Strobes or approved equals
– HiFi speakers are designed for a field-selectable input of either 25 or 70 VRMS,
and with selectable power taps from 1/8 Watt to 2 Watts
– Both HiFi ceiling and wall-mount models have listed sound outputs of up to
87 dBA at 3.3 meters (10 feet), and a listed frequency response of 300 to 8000 Hz
– Speaker appliances feature sealed-back construction for optimum audibility
– All inputs use terminals that accept
#
12 to
#
18 AWG wire sizes
– Strobe intensity, where multi-Candela appliances are specified,
have six (6) field-selectable settings, and are rated for:
▪ 15/30/75/110cd (wall mount)
▪ 135/185cd (wall mount, high Candela)
▪ 15/30/75/95cd (ceiling mount)
▪ 115/177cd (ceiling mount, high Candela)
– Selector switch, which used for selecting the candela, is tamper-resistant by design
– The strobe portion, when synchronization is required, is compatible when used with any of the following:
▪ 252 / 504-point addressable control panels
▪ Siemens Modular and FireFinder® XLS control panels
▪ Siemens Dual-Sync Control Modules -> Model DSC-series with built-in sync protocol
▪ Siemens PAD-series of NAC Extenders
– Siemens Series ‘SEH’ meets the requirement for low-frequency signal tone, when used with:
▪ One (1) Amplifier Card {Model VCI2001-U1} with Siemens 252-point / 504-point addressable FACPs
▪ One (1) Booster Amplifier {Model EBA200x Series} with Siemens 252-point / 504-point addressable FACPs
▪ One (1) 40W Zone Amplifier Card {Model ZAC-40} with Siemens Modular and FireFinder XLSV
– The strobes do not drift out of synchronization at any time during operation
Note: ADA Guidelines specify a flash rate of 1-to-3 flashes per second
– ‘SEH’-series strobes revert to a non-synchronized flash-rate, if the dual-sync module or
the Siemens PAD-series NAC Extenders should fail to operate (i.e. – contacts remain closed)
– HiFi ceiling speaker and speaker-strobe appliances are designed for indoor, flush mounting
– Wall-mount speaker and speaker-strobe appliances are designed for indoor flush mounting
to 10.2 cm. —x— 5.4 cm. (4” —x— 2-
1/8
”) electrical boxes without the need for an extension ring or surface mounting
▪ Model SPEXT is an optional extender used for mounting to 10.2 cm. [4”] back boxes without a ring
– HiFi speakers and speaker-strobe incorporate a speaker-mounting plate with a snap-on grille cover:
▪ Low-profile design allows for faster and easier installation speaker mounting plate
– Series ‘SEH’ HiFi speakers and speakers strobes is available for ordering in either white or red
Wiring Diagram
(Shown In Inches)