Operating Instructions

Descriptions of Parameter Settings
Descriptions of Parameter Settings
109 | 443
Settings
Functions
Descriptions
13
Cancel the setting of auto-
acceleration / auto-deceleration
time
Set Pr.01-44 to one of the 01–04 setting modes before using this function. When this
function is enabled, OFF is for auto mode and ON is for linear acceleration /
deceleration.
15
Rotating speed command from
AVI
ON: force the source of the drive’s frequency to be AVI. If the rotating speed commands
are set to AVI and ACI at the same time, the priority is AVI > ACI.
16
Rotating speed command from
ACI
ON: force the source of the drive’s frequency to be ACI. If the rotating speed commands
are set to AVI and ACI at the same time, the priority is AVI > ACI.
18
Force to stop (Pr.07-20)
ON: the drive ramps to a stop according to the Pr.07-20 setting.
19
Digital up command
ON: the frequency of the drive increases or decreases by one unit. If this function
remains ON continuously, the frequency increases or decreases according to Pr.02-09 /
Pr.02-10.
The Frequency command returns to zero when the drive stops and the displayed
frequency is 0.00 Hz. If you select Pr.11-00, bit 7 = 1, the frequency is not saved.
20
Digital down command
21
PID function disabled
ON: the PID function is disabled.
22
Clear the counter
ON: the current counter value is cleared and displays 0. The drive counts up when this
function is disabled.
23
Input the counter value (MI6)
ON: the counter value increases by one. Use the function with Pr.02-19.
24
FWD JOG command
This function is valid when the source of the operation command is the external terminal.
ON: the drive executes forward JOG. When executing the JOG command in torque
mode, the drive automatically switches to speed mode. The drive returns to torque mode
after the JOG command is complete.
25
REV JOG command
This function is valid when the source of the operation command is the external terminal.
ON: the drive executes reverse JOG. When executing the JOG command in torque
mode, the drive automatically switches to speed mode. The drive returns to torque mode
after the JOG command is complete.
26
TQC / FOC mode selection
ON: TQC mode, OFF: FOC mode.