Operating Instructions

Descriptions of Parameter Settings
Descriptions of Parameter Settings
172 | 443
84: W-phase output phase loss (oPL3)
●
87: Low frequency overload protection (oL3)
●
89: Rotor position detection error (roPd)
●
101: CANopen guarding error (CGdE)
●
102: CANopen heartbeat error (CHbE)
●
104: CANopen bus off error (CbFE)
●
105: CANopen index error (CidE)
●
106: CANopen slave station setting error (CAdE)
●
107: CANopen index setting exceed limit (CFrE)
●
111: InrCOM time-out error (ictE)
●
121: Internal communication error (CP20)
●
123: Internal communication error (CP22)
●
124: Internal communication error (CP30)
●
126: Internal communication error (CP32)
●
127: Internal communication error (CP33)
●
128: Over-torque 3 (ot3)
●
129: Over-torque 4 (ot4)
●
134: Electronics thermal relay 3 protection (EoL3)
●
135: Electronics thermal relay 4 protection (EoL4)
●
140: Oc hardware error (Hd6)
●
141: GFF occurs before run (b4GFF)
●
142: Auto-tuning error 1
(no feedback current error) (AUE1)
●
143: Auto-tuning error 2
(motor phase loss error) (AUE2)
●
144: Auto-tuning error 3
(no-load current I
0
measuring error) (AUE3)
●
Pr.
Explanation
Settings
Default
06-29
PTC detection selection
0: Warn and continue operation
1: Fault and ramp to stop
2: Fault and coast to stop
3: No warning
0
● Sets the operation mode of a drive after detecting PTC.
Pr.
Explanation
Settings
Default
06-30
PTC level
0.0 to 100.0%
50.0
● Sets AVI / ACI analog input function Pr.03-00–03-01 to 6 [thermistor (PTC) input value)].
● Use this parameter to set the PTC level; 100% PTC level corresponds to the maximum analog input value.