Operating Instructions

Summary of Parameter Settings
10 Speed Feedback Control Parameters
65 | 443
Pr.
Explanation
Settings
Default
09-80
Communication card address
mask 1 (for Modbus TCP)
0 to 255
0
09-81
Communication card address
mask 2 (for Modbus TCP)
0 to 255
0
09-82
Communication card address
mask 3 (for Modbus TCP)
0 to 255
0
09-83
Communication card address
mask 4 (for Modbus TCP)
0 to 255
0
09-84
Communication card gateway
address 1 (for Modbus TCP)
0 to 255
0
09-85
Communication card gateway
address 2 (for Modbus TCP)
0 to 255
0
09-86
Communication card gateway
address 3 (for Modbus TCP)
0 to 255
0
09-87
Communication card gateway
address 4 (for Modbus TCP)
0 to 255
0
09-88
Communication card password
(low word) (for Modbus TCP)
0–99
0
09-89
Communication card password
(high word) (for Modbus TCP)
0 to 99
0
09-90
Reset communication card (for
Modbus TCP)
0: Disable
1: Reset to defaults
0
09-91
Additional settings for the
communication card (for Modbus
TCP)
bit 0: Enable IP filter
bit 1: Enable internet parameters (1 bit)
When the IP address is set, this bit is enabled. After updating the
parameters for the communication card, this bit changes to disabled.
bit 2: Enable login password (1 bit)
When you enter the login password, this bit is enabled. After updating
the communication card parameters, this bit changes to disabled.
0
09-92
Communication card status (for
Modbus TCP)
bit 0: Enable password
When the communication card is set with a password, this bit is enabled.
When the password is cleared, this bit is disabled.
0
10 Speed Feedback Control Parameters
indicates the parameter can be set during operation.
Pr.
Explanation
Settings
Default
10-00
Encoder type selection
0: Disabled
5: Pulse input (MI7)
0
10-01
Encoder pulses per revolution
1 to 20000
600
10-02
Encoder input type setting
0: Disable
5: Single-phase input (MI7)
0