Operating Instructions

Chapter 3 – Startring EasyComm
Siemens Building Technologies, Inc. 17
Chapter 3 - Starting EasyComm
1. To start EasyComm, double-click SED2 EasyComm on your desktop.
The following window displays.
Figure 20.
2. To begin with factory default parameter settings, do one of the following:
− Click the upper left New parameter set with factory setting
.
− From the File menu, click New, Based on Factory Settings
.
NOTE:
From the File menu, click New and then Empty Parameter Set
to open a completely new parameter set with no settings.
From the File menu, click Open
to open an existing parameter
set.
From the File menu, click Parameter Sets Last Dealt With to open a
recently-accessed parameter set.
3. Fill in the fields as follows. When you are finished, click OK.
Unit Type – Set to SED2 Easy Drive.
Short Type – Not selectable.
Unit Version – Set to correspond to the drive firmware version (parameter r0018
reads/displays the drive firmware version).
Technology Type – Not selectable.
Bus Address – Typically 0, unless there are more than one drive on a network.
NOTE: Multiple drive operation is not supported for North American operations.