Installation Instructions

Document No. 129-393
Installation Instructions
October 2, 2009
Page 10 of 15 Siemens Industry, Inc.
12. Set Motor Frequency and Unit of Measurement
DIP switches (Figure 30) as follows:
DIP
Switch
Position Function
1 OFF
Not for customer use.
NOTE: This switch must
remain OFF for proper
operation.
2 ON
North American operation
(60 Hz, hp).
Figure 30. Setting Control Board DIP Switches.
13. Reinstall operator panel release button by using
a needle nose pliers to reinsert wire spring in
retaining slots (Figure 31).
Verify that the release button and wire spring are
correctly mounted and securely in place.
Figure 31. Reinstalling Operator Panel
Release Button.
14. Reattach I/O Module (Figure 32).
Figure 32. Reattaching I/O Module.
15. Reattach the operator panel extension module
(Figure 33).
Figure 33. Reattaching Operator Panel
Extension Module.