Installation Instructions

Document No. 129-393
Installation Instructions
October 2, 2009
Page 6 of 15 Siemens Industry, Inc.
13. Reattach I/O module (Figure 15).
Figure 15. Reattaching I/O Module.
14. Reinstall terminal cover, operator panel, and
cover (Frame Sizes B and C). See Figures 16
and 17.
Figure 16. Reinstalling Terminal Cover and
Operator Panel.
Figure 17. Reinstalling Cover (Frame Sizes B and C).
15. Update drive label "issue" field on outside of
drive from "V1.17", "V1.20", or “V1.30” to
“V1.4x”.
This completes installation. Continue with the
Startup section.
Installation for SED2 Frame Size
D, E, and F
CAUTION:
Do not use this upgrade if your control
board is Version 1.15 (V1.15). If
upgrading a V1.15 Control Board,
contact your field support for assistance.
1. If on a network, read and record the address of
parameter P0918 here:
WARNING:
Make certain SED2 supply power is
disconnected.
2. Remove operator panel and terminal cover
(Figure 18 and 19). Set aside operator panel
and terminal cover for reassembly.
Figure 18. Removing Operator Panel.