Operating Instructions

Appendix A: Parameter Reference List
Siemens Building Technologies, Inc. 133
Dependency: If no sensor is selected, motor temperature monitoring occurs based on the estimated value of the thermal motor
model.
P0610 Motor I2t temperature reaction
Min: 0 Def: 2 Max: 2
Level 3
Enum: 0=No reaction, warning only 1=Warning and Imax reduction (results in reduced output
freq.)
2=Warning and trip
(F0010)
P0640 Motor overload factor [%]
Min: 10.0 Def: 150.0 Max: 400.0
Level 2
Dependency: Limited to maximum inverter current or to 400% of rated motor current (P0305), whichever is the lower
P0700[2] Selection of command source
Min: 0 Def: index dependent Max: 6
Level 1
Enum: 0=Factory default setting
1=BOP (keypad)
2=Terminal
4=USS on BOP link
5=USS on COM link
6=CB on COM link
Index: P0700[0] : IN000 (AUTO) 1st. Command data set
(CDS)
P0700[1] : IN001 (HAND) 2nd. Command data set (CDS)
Note: Changing this parameter resets (to default) all settings on item selected. For example: changing from 1 to 2 resets
all digital inputs to default settings.
P0701[2] Function of digital input 1
Min: 0 Def: 1 Max: 99
Level 2
Enum: 0=Digital input disabled
1=ON/OFF1
2=ON reverse /OFF1
3=OFF2 -coast to standstill
4=OFF3 -quick ramp-down
9=Fault acknowledge
10 =JOG right
11 =JOG left
12 =Reverse
13 =MOP up (increase freq.)
14 =MOP down (decrease freq.)
15 =Fixed setpoint (Direct selection)
16 =Fixed setpoint (Direct selection + ON)
17 =Fixed setpoint (Binary coded
selection+ON)
25 =DC brake enable
26 =Enable Essential Service
27 =Enable PID
29 =External trip
33 =Disable additional freq
setpoint
99 =Enable BICO
parameterization
Index: P0701[0] : IN000 (AUTO) 1st. Command data set
(CDS)
P0701[1] : IN001 (HAND) 2nd. Command data set (CDS)
Dependency: Setting 99 (enable BICO parameterization) requires P0700 (command source) or P3900 (end of quick
commissioning)=1, 2 or P0970 (factory reset)=1 in order to reset.
Note: Setting 99 (BICO) for expert use only
P0702[2] Function of digital input 2
Min: 0 Def: 12 Max: 99
Level 2
Detail: See P0701 (function of digital input1).